7
wherever possible.
• Always follow proper procedures for crossing the side of a hill as described in this manual. Avoid hills with
excessively slippery or loose surfaces. Shift your weight to the uphill side of the vehicle. Never attempt to turn
the vehicle around on any hill until you have mastered the turning technique on level ground. Avoid crossing the
side of a steep hill if possible.
• Use proper procedures if you stall or roll backwards when climbing a hill. To avoid stalling, use proper gear and
maintain a steady speed when climbing a hill. If you stall or roll backwards, follow the special procedure for
braking. Dismount on the uphill side or to a side if pointed straight uphill. Turn the vehicle around and remount.
• Always check for obstacles before operating in a new area.
• Never attempt to operate over large obstacles, such as large rocks or fallen trees.
• Be careful when skidding or sliding. Learn to safely control skidding or sliding by practicing at low speeds and
on level, smooth terrain. On extremely slippery surfaces, such as ice, go slowly and be very cautious in order to
reduce the chance of skidding or sliding out of control.
• Never operate a CRICKET in fast-flowing water or excessively deep waters. Contact with water may affect the
batteries and may reduce stopping ability. Test your stopping ability after leaving water by removing pressure
from accelerator pedal rapidly several times in a row.
• Always use the size and type tires specified in this manual.
• Always maintain proper tire pressure as described in this manual. (22 PSI)
• Never modify a CR1CKET vehicle through improper installation or use of accessories.
• Never exceed the stated load capacity for a vehicle, Cargo should be properly distributed and securely attached.
Reduce speed and follow sound procedures for carrying cargo or pulling a trailer. Allow greater distance for
braking.
CRICKET Installation and Setup Instructions
Once you have safely and completely removed your vehicle from its shipping crate, you are ready to perform the
basic installation and set-up procedures prior to the initial operation of your new CRICKET Grasshopper.
*You may dispose of the protective barrier.
1. Unpack the CRICKET Vehicle
1.1. Remove all packing material including the rear step plate and the front seat from the CRIKCET. Set these items
aside until needed.
2. Install the Steering Shaft
2.1. Make sure the steering wheel in the correct orientation for driving straight and the front wheels are pointing
straight. Line up the square pin (Fig. 2.1.1) on the lower shaft with the upper shaft and slide the two shafts
together. Then tighten the large nut on the upper shaft until tight. (Fig. 2.1.2)
Figure 2.1.2 Grasshopper Steering Shaft Nut
Figure 2.1.1 Grasshopper Lower Steering Shaft
To Next Page
Loading...
