08
Installing the Water Line
Installing the Water Line
• Water line installation kits are available
as an addional accessory from your
dealer or at a local hardware store.
1. First, shut off the main water supply line
and turn the ice-maker off.
2. Locate the nearest cold water supply
valve.
3. After connecting the water supply to the
water valve, turn your main water supply
back on and ush several gallons of water
to clear the water supply line.
Connecting the Water Line to The
Refrigerator
• There are several items that you need to
purchase to complete this connection.
• You will nd these items sold as a kit at
your local hardware store.
4. First, close the main water supply and
locate the nearest cold water line.
5. Second, connect the water valve to the
cold water line.
6. Turn water valve on and check for any
leakage.
7. When moving the refrigerator, you can
hang the power cord on the power cord
hook.
Connecting the Water Line to A
Drinkable Water Source
• If your water line is not drinkable, please
add an external water lter.
• If you must repair or disassemble the
water line, cut off the plastic tubing to
make sure you get a snug, leak-free
connection.
ATTENTION
• The minimum inlet water pressure: 276kPa
.
• The maximum inlet water pressure: 689kPa.
• Connect to potable water supply only new
hose-sets supplied with the appliance are to
be used and that old hose-sets should not be
reused.
Power cord hook
Water line
Water connector
Cold water line
Pipe clamp
Shut off walve
Water line installation kit
Water connector
Water tube
To Next Page
Loading...
