17
the child lock has been enabled. The control panel is now locked. In this mode, only the <Start>
icon on the control panel is operational. All other icons are locked and inactive. When other icons
on the control panel are touched, the “Child Lock” icon will illuminate and blink and at the same
time the control panel will emit an “invalid” tone. If “Child Lock” is not disabled within 3 seconds,
the “Child Lock” will stay enabled and oven will remain in the current working order while control
panel is locked.
Note: The “Child Lock” function is only eective in “Standby” and “Working” modes.
The Child Lock only disables control panel functionality. IT DOES NOT
LOCK THE OVEN DOOR IN ANY MODE !!!
7. Timer Function
This range is equipped with a timer function. Timer can be used in standby or working modes. To
enable the timer function, follow steps below.
1. Touch the <Timer> icon by the numeric keypad on control panel to initiate timer function. The
timer should display the 0:00 on the control panel.
2. Enter the desired time value for the timer. Hour & minute values will display accordingly.
3. Touch the <Timer> icon again to conrm your setting. The timer will be enabled.
4. Note: If timer is set in the standby mode, the timer value will be displayed on the control
panel continuously. If timer was set in working mode, the timer countdown will not be display
continuously, instead the timer icon will be displayed.
5. At the end of the timer countdown, a buzzer will sound and the timer symbol on control panel will
blink 00:00. Touch the <Timer> or <Cancel> icon to turn the timer o. If timer is not turned o by
hitting the <Timer> or <Cancel>, the control panel will blink 00:00 and the timer buzzer will sound
for one minute. After one minute, the timer will shut o, buzzing sound will stop and 00:00 will
disappear from control panel display.
Note: Maximum allowable range for time function is 12:00 hours.
! IMPORTANT !
To Next Page
Loading...
