27
Note: place the product at a distance less than 70 cm
from the sensor� Attach the product within a 30° angle to
the sensor (Fig� C)�
Connecting the product to the sensor
Use the magnet (6) to turn the sensor (4) on� The speed
trend (20) shows a curve to confirm successful connec-
tion� The product is now ready for use�
If the connection fails, follow the steps in the section
‘Troubleshooting’ and reset all basic settings� You will
then have to reconnect the product with the sensor�
Functions
• ADVANCE mode: you can select the following
function displays by pressing the ‘MODE’ button
(15): CLOCK > TOTALODO > TOTAL-TM > TRIPDIST
> MAXSPEED > AVGSPEED > TRIPTIME > TEMP >
STPWATCH > CAL RATE > CALORIE > FAT-BURN
> CO2 KG > FUELSAVE > ETASTART > KM+/- >
TIME+/- > SCAN
• EASY mode: you can select the following functions
by pressing the ‘MODE’ button (15): TRIPDIST >
MAXSPEED > AVGSPEED > TRIPTIME
Note: you can also individually set the functions you
desire� Refer to the section ‘CUSTOMIZE’ mode�
GB
To Next Page
Loading...
