Crivit CSP 12 A1 User Manual

CSP 12 A1
■ 6
│
GB
│
IE
Setting the pressure
♦ Press the "+" button or the "-" button to
set the desired pressure.
TIP
► If you press and hold down the "+" button
or the "-" button , the pressure setting
changes quickly.
NOTE
► The compressor switches off automatically
when the preset pressure has been reached.
► The display
flashes quickly to remind you
to switch off the appliance, otherwise it will
be switched off by the overheating protection.
Switching on and off
Switching on the appliance
♦ Press the ON/OFF switch
.
♦ Press and hold the ON/OFF switch
for about
3 seconds to switch directly to high-pressure
mode.
Switching off the appliance
♦ Press the ON/OFF switch
again.
Setting up
Inflating/deflating
♦ Fit the locking connection of the hose onto
the desired adapter. To inflate, use the inflation
connection . To deflate, use the deflation
connection .
♦ Turn it clockwise until it is fixed firmly in place.
Attachments
♦ Screw the adapter onto the adapter
connection of the hose anticlockwise until it
is fixed firmly in place.
♦ Screw the adapter
or onto the adapter
connection of the hose clockwise until it is
fixed firmly in place.
♦ Push the desired adapter into your SUP board
and follow the manufacturer's instructions.
High-pressure attachment
The high-pressure attachment makes it easier to
fill SUP boards.
The middle seal, which is preassembled on the
adapter, is used as standard.
If air leaks occur during operation, please use the
thickest gasket. If you cannot insert the attachment
into the object, please use the thinnest seal.
Mini-Boston valve adapter
The mini-Boston valve adapter can be used to
inflate small inflatable mattresses.
Boston valve adapter
The Boston valve adapter can be used to inflate
various inflatable mattresses.
Changing the fuse
The 12 V vehicle connector plug contains a
fuse. If the appliance is not working, the fuse may
be defective. Exchange the defective fuse for a
replacement fuse of the same type (see also sec-
tion Technical data).
♦ To do this, pull the 12 V vehicle connector
plug
out of the cigarette lighter socket.
♦ Open the 12 V vehicle connector plug
by
carefully unscrewing the grooved screw insert
(C) anticlockwise (using pliers if necessary) and
removing it.
♦ Now, remove the plug tip (B) from the fuse (A),
remove the fuse (A) and place it to one side.
♦ Now insert a new 15 A fuse into the 12 V
vehicle connector plug , place the plug tip
(B) onto the slightly protruding end of the fuse
and screw the previously removed screw insert
(C) back in.
NOTE
►
If the appliance still does not work or the fuse
blows again immediately, the appliance is
defective. Please contact the Service Hotline
(see section Service).

Crivit CSP 12 A1 Specifications

General

Brand	Crivit
Model	CSP 12 A1
Category	Water Pump
Language	English