Owner's Manual VE-1P Vertical Edger
Page 27 of 33
SECTION 7
TROUBLE SHOOTING PROCEDURES
PROBLEM POSSIBLE SOLUTION
Glass rides up in grinding Check the coolant
compartments Dress the diamond wheel
Check the infeed & outfeed levelness
Check for glass interference with the outfeed
rollers
Interference of glass with glass racks or rollers
Decrease depth of cut
Choppy edge Check the coolant
Check the glass for interference with infeed
rollers
Redress the diamond wheel
Check the motor mounting & adjusting screws
for tightness
Re-true the diamond wheel
Chipped edge or starred Check the coolant
edge Check the wheel suitability for the glass
thickness
The wheel is turned to far and the steel is
contacting the glass
The wheel is worn out
Try a finer wheel grit
Run the wheel straight on
Glass drops in conveyor Check the infeed and outfeed for levelness
section Glass hitting the outfeed
To Next Page
