Owner's Manual VE-1P Vertical Edger
Page 3 of 33
SECTION 1 (continued)
1) Always operate and maintain the edger in accordance with the instructions
and procedures in this manual.
2) Do not exceed the capacity of the edger.
3) Do not open inspection doors while unit is in operation except in special
circumstances which are addressed later in this manual.
4) Never work on the edger and related components unless electrical power and
motor drive have been locked out and tagged.
5) Do not use edger for any purpose for which it was not designed. It is to be
used solely to edge glass within the specification limits listed in this manual.
6) Do not poke or prod into the openings of the edger with a bar or stick.
7) Always have a clear view of the loading and unloading points and all safety
devices of the edger.
8) Always keep area around edger, drive, and control station free of debris
and obstacles.
9) Never operate edger without guards and all safety devices in position and
functioning.
10) Always allow edger to stop naturally. Do not attempt to artificially brake
or slow the motion of the edger.
11) Always wear safety glasses, proper gloves, and other necessary safety
equipment while operating and maintaining the edger. When in doubt,
consult with shop safety representative.
To Next Page
