Turntable Maintenance
1. Do not touch the stylus tip with your fingers. Avoid bumping the stylus on the turntable mat or a record’s edge.
2. Clean the stylus frequently with a soft brush with a back-to-front motion only.
3. Clean the records to get rid of dust or grease with a record cleaning brush and record cleaning solution.
4. Clean the turntable lid and turntable cabinet with a slightly damped microfiber cloth.
Note: Do not use cleanser other that contains alcohol, benzene or any other harsh chemicals, which might damage the paint and finish
of the turntable.
** Crosley offers a product line of different cleaning accessories. Please ask your retailer or check out our
website www.crosleyradio.com for more cleaning product information.
Troubleshooting
There is no power
•
Power adaptor is not connected correctly.
•
No power at the power outlet.
Power is on, but the platter does not turn
•
Turntable’s drive belt is not installed or has slipped off.
Turntable is spinning, but there is no sound, or sound not loud enough
•
Stylus protector is still on.
•
Tone arm is lift up by the lever.
Record sounds too fast or too slow.
•
Wrong speed selected for the record.
Strong hum on phono input
•
The cable is not grounded correctly
FCC Statements
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct
the interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio TV technician for help.
To Previous Page
Loading...
Need help?
General
