25
Note
• Do not use detergent and softner
• Should open the Cold water tap in order to get the best dry performance.
• After finishing this program, is showed on PCB board alternately and the smoothing creases
program is conducted during 30 minute and then power is OFF.
• Be careful of high temperature when pulling out clothes.
• A little shrinkage and deformation will be possibly happened after drying, so check whether each clothing is
suitable for high temperature dry.
• If the dry performance is poor, change the dry condition selected.
DRY
a) Dry only
b) Dry after wash
• You can set this washer to perform wash and dry within one cycle.
• If you want to operate quickly, select the "Wash-Dry" program by program selection dial.
• If you want to dry after wash,
Note
• "Wool", "Delicate", and "Blanket" programs can not be used with "Dry" in order to care the fabric.
1
2
3
4
Put the laundry into the Drum and close the Door
Press the Power button
• The LED shows only "---"signal
Select the "Dry condition" by pressing "DRY" button.
As this button is pressed, the dry condition is selected by 'Normal' -> 'More'
-> '30/60/90(min)' -> OFF -> 'Low Temp' -> 'Less' -> 'Normal'
Press the Start/Pause button
• The washer will operate with locked Door.
1
2
3
Select and set up wash program as guided on the previous pages, up to the
procedure before pressing "Start/Pause" button.
Press "Dry" button and select the "Dry condition" :
Normal ->More -> 30/60/90(min) -> OFF -> Low Temp -> Less -> Normal
Press the Start/Pause button.
• The washer will operate with locked Door.
To Next Page
Loading...
Need help?
General
