3. Press the skip up or skip down button to select the desired mode (USB
or SD) for encoding, then press the record REC button again to confirm.
(You can skip this step if only a USB drive or an SD/MMC card is inserted.)
4. The system will start the encoding mode after a few seconds. During encoding, the
USB or SD icon will be flashing on the display.
5. To finish encoding, press the stop button. The display will show “END” and
return to PHONO/AUX mode.
NOTE:
⚫ The recording speed is 1:1. Recording will take as long as playing the CD (or other
auxiliary input).
⚫ The recording format is preset at MP3 bit rate 128 kbps.
To Next Page
Loading...
Need help?
General
