Phono encoding
1. Set the function button to PHONO mode and then insert a memory device (USB drive,
SD or MMC card).
2. Put your record onto the turntable and get it ready for playback.
3. Press the record REC button. It will take about 3 - 4 seconds to read the
memory device, then the USB or SD icon will be flashing on the LC display.
4. Press the skip up or skip down button to select the desired mode (USB
or SD) for encoding, then press the record REC button again to confirm.
(You can skip this step if only a USB drive or an SD/MMC card is inserted.)
5. The system will start the encoding mode after a few seconds.
6. Lower the tone arm to start playback of the record. During encoding, the USB or SD
icon will be flashing on the display.
7. To finish encoding, press the stop button. The display will show “END” and return to
PHONO mode.
NOTE:
⚫ The recording speed is 1:1. Recording will take as long as playing the record.
⚫ The recording format is preset at MP3 bit rate 128 kbps.
Cassette Operation
1. Cassette Button Indicators
2. Cassette Button Control
a) RECORDER-------Copy RADIO / PHONO /AUX IN / CD / USB / SD to TAPE
b) PLAYER--------------Play tape tracks
c) REVERSE
d) FORWARD
e) STOP/EJECT--------1
st
push – Cassette function stop, 2
nd
push open cassette door
f) PAUSE-----------------Pause when cassette in Playback mode.
To Next Page
Loading...
Need help?
General
