3. Cassette PlayBack Control Operating
1) TAPE Play:
a) Function Choose to “TAPE” mode---Push “EJECT” key under tape----Open cassette
tape door-----put your tape into cassette dock----Manual close the tape door –Press
“PLAYER” Key ------ To adjust the volume level for your preference, turn the volume knob
to the right or left
b) Press “PAUSE” button once to stop playing, press it again to continue
C) When TAPE tracks play ending, “PLAYER” Key up automatically.
2) REVERSE ----------When Cassette Stop -------Press “REVERSE”.
3) FORWARD----------When Cassette Stop -------Press FORWARD.
4) STOP/EJECT-----1
st
push – Cassette function stop, 2
nd
push open cassette
5) RECORDER--------Recording from RADIO / PHONO /AUX IN / CD / USB / SD
to TAPE
a) RADIO / PHONO /AUX IN / CD / USB / SD-------During playing -------Press
Tape”EJECT”----Open tape door-----Put a blank tape into Cassette Dock----close the
door-----Press RECORDER&PLAYER together same time-----Now start the recording
songs to the tape------- Press “PAUSE” button if need to pause recording , press it again
to continue recording.
b) Press “STOP” to stop recording.
c) When recording finished (Tape is full-end), “RECORDER&PLAYER “ Auto Key-up.
IMPORTANT!
When using the cassette deck
⚫ Make sure to insert the cassette in the correct direction.
⚫ To avoid damaging the cassette, we strongly recommend
taking it out of the equipment after playing the cassette.
⚫ In case erase tape tracks by improper operation, you can choose take
off anti-erase tap (write protection) to finalize the recorded-tape.
For the same principle, if take off anti-erase tap,this tape
would not be able to write new contents/songs.
(Anti-erase taps position)
To Next Page
Loading...
Need help?
General
