Introduction Gasman
8
i-module gas sensor
Gasman uses unique plug and play i-module sensor technology. Each
sensor unit incorporates its own intelligent processor holding sensor
configuration and calibration data. Different sensors can be purchased,
and once inserted, are immediately ready to run. Flammable units are only
available with rechargeable batteries. Plug and play will ease maintenance
time and cost, and the intelligent modular system will remove the need
to calibrate the sensor. Gasman can be reconfigured by purchasing
additional pre-calibrated i-modules from Crowcon or your local office.
After fitting a new i-module, it is recommended that a gas test is carried
out on the detector before use.
Reliable, anti-shock mechanics and robust housing
The Gasman housing is built from resilient material, giving it strength and
flexibility to withstand the hardest of working conditions, water and dust
tight to IP65 with a non-slip grip. If the unit is dropped, there will be no
disruption of power or function, ensuring reliability and service for years
to come.
Software
The internal software in Gasman has been designed and written in
accordance with the requirement of IEC 61508 to ensure quality and
integrity of operation. Gasman has been designed to give a truly
reliable personal gas monitoring system. The internal circuitry includes
an independent watchdog. The software monitors for any malfunction
within the unit and will display an error warning to the user should they
occur.
To Next Page
Loading...