Crown D-150 - Page 40

Power Requirements
Heat Sinking
Controls
input Connector”
Requires 50-400 Hz AC connectable tor
120V or 240 VAC £10%. Draws 30 watts
or less on idle. rans 200 Hat ot ee at
250W out into 8 Ohm. Qo
Entire chassis is used as heat sink.
Chassis is a rugged heavy gauge
alurninurh.extrusion for maximum. heat ©
Input level ‘control mounted adjacent to
ifiput ~ 14” phone ack
Output ~~ = Color coded binding posis.
Center teintinals &f ditt @) coded
‘ack,
Balanced
outputs.
coded
red.
40
Dimensions
Weight
Finish
AC Line — Three-wire (rounded) male
connector on 5.ft. minimum. cable.
16%" long, 5" wide, and 8” high (without
panel), 17” jong, 5%" high, 8%" deep
with front pane! (optional). 19" standard
rack mounting hardware inetd with
front panel. :
22 1b. Tet wt 24'tb. with front panel
Black. anodized chassis,
Front-panel-(optional) is brightanodized
brushed aluminum with black
leatherette tower panel.