CRRC MS-BT20 - Page 14

12
Collar not
completely swaged.
Improper tool operation.
Operate the tool
correctly as per
section 3.4.
Scored anvil.
Replace the anvil.
Tool "hangs up" on
swaged collar of
fastener
Improper tool operation.
Operate the tool
correctly as per
section 3.4.
Jaws in wrong
position.
Improper operation.
Check and re-install
the spring.
Note: In case of any unsolvable problems, please disconnect the power supply
of tool immediately and consult the technicians of Meishan.