*1: whichever comes first shall be prevailed.
Note: the Warranty and Life Cycle are based on standard operation and proper maintenance
without artificial damage.
Requirements on replacing consumables and wear parts:
1. the trained bench worker is required using specific tools.
2. the warranty period of TOOL components shall NOT be re-calculated by replacing wear parts.
3. if the TOOL is failed during warranty period, send it to Meishan or its authorized service center
to repair.
Requirements for use:
1. Check and confirm no obvious crack on tool;
2. Hold tool trigger depressed for 30 seconds; depress trigger a few times to cycle tool and to
circulate hydraulic fluid. Observe action of tool and check for leaks.
3. Check and confirm the pressure is correct.
To Next Page
