Need help?Do you have a question about the Crunch GTR1100.2 and is the answer not in the manual?
General| Channels | 2 |
|---|---|
| Input Sensitivity | 200mV - 6V |
| Crossover Type | Variable |
| Low Pass Crossover Frequency | 50Hz - 250Hz |
| High Pass Crossover Frequency | 50Hz - 250Hz |
| Bass Boost Frequency | 45Hz |
| Bass Boost | 0dB / +6dB / +12dB |
Covers system design considerations for a successful car stereo setup, emphasizing component quality and placement.
Details amplifier mounting, wiring, power/ground connections, safe connection sequence, and system power-up procedures.
Details features for GTR1100.2 (2-channel), GTR1000.4 (4-channel), and GTR1000D/2000D/3000D (1-channel mono).
Illustrates the basic application for the GTR Series 2-channel amplifiers in a full range stereo configuration.
Demonstrates the basic mono bridging method for Crunch 2-channel amplifiers using a subwoofer.
Explains a 2-way active or bi-amplified system setup using one amplifier for highs and another for lows/sub.
Shows how to use the 4-channel amplifiers as discrete 4-channel full range units.
Details using the 4-channel amplifiers in a 3-channel system by mono bridging a channel pair.
Details the basic application for these D Class 1-channel sub-bass amplifiers in bi-amplification systems.
Provides specific setup instructions for High Pass, Bass EQ, and Level controls for these amplifier models.
Offers setup guidance for Subsonic, Bass EQ, and Level controls for these mono amplifier models.
Explains the diagnostic system, PROTECT LED indicators, and common causes for amplifier shutdown.
Covers causes and solutions for amplifier heatsink overheating, including inadequate cooling and impedance.
Troubleshooting steps for low output power, including checking level controls, battery voltage, and connections.
Identifies reasons for fuses blowing, such as incorrect impedance, short circuits, or faulty amplifiers.
Guides on diagnosing issues when the system does not turn on, checking fuses, connections, and voltages.
Addresses hiss, electrical interference, and RPM-related noise, providing isolation and resolution steps.
Outlines the 1-year warranty for defects in material and workmanship, exclusions, and limitations.
Details the MX-1 converter for converting high-level speaker outputs to low-level RCA outputs.
Describes the MX-3 bass controller for shaping subwoofer output signals and controlling bass response.
Explains the MX-2 converter for high-level to low-level signal conversion with audio signal sense.
Details the MX-4 converter for adding a subwoofer signal from high-level speaker wires.
Describes the MLX-100 device for linking or strapping mono amplifiers to share pre-amp features.
To Next Page
