Need help?Do you have a question about the Crunch GTR3000D and is the answer not in the manual?
General| Number of Channels | 1 |
|---|---|
| Signal to Noise Ratio | >90 dB |
| Bass Boost | 0-12dB |
| Amplifier Class | D |
| Total Power | 3000W |
| Frequency Response | 10Hz - 250Hz |
| Input Sensitivity | 0.2V - 6V |
| Phase Shift | 0-180 Degrees |
Discusses the importance of system design for car stereo success.
Details the physical mounting and placement of the amplifier.
Covers wiring best practices, avoiding electrical noise.
Explains proper gauge cables and connection methods for power and ground.
Outlines the order for connecting cables to avoid damage.
Provides a step-by-step guide for safely powering on the system for the first time.
Outlines common features across all Crunch GTR amplifiers.
Details the specific features and controls of the GTR1100.2 model.
Explains the features and controls for the GTR1000.4 model.
Describes the features and controls for the mono block amplifier series.
Basic application for full-range stereo sound with the 2-channel amp.
Illustrates the basic mono bridging method for 2-channel amps.
Details using the 2-channel amp for high frequencies and another for low-pass.
Shows how to use the 4-channel amp as four discrete full-range units.
Demonstrates using the 4-channel amp in a 3-channel system via mono bridging.
Basic setup for sub-bass amplifiers, integrating with other systems.
Specific guidance for setting up GTR110.2 and GTR1000.4 amplifiers.
Specific guidance for setting up mono block GTR amplifiers.
Explains the amplifier's diagnostic and protect mode features.
Discusses causes and solutions for amplifier overheating.
Addresses potential causes and fixes for low output power.
Explains reasons why amplifier fuses might blow and how to check.
Steps to diagnose why the system is not powering on.
Covers issues related to hiss and electrical interference.
Identifies sources and solutions for engine-related noise.
Discusses causes and fixes for persistent system noise.
Features and functions of the MX-1 converter.
Features and functions of the MX-3 bass controller.
Details the MX-2 deluxe converter's capabilities.
Explains the MX-4 add-a-sub converter's features.
To Next Page
