Need help?Do you have a question about the Crunch V-Drive V2200 and is the answer not in the manual?
Describes the basic full range application for 2 channel V-Drive amplifiers.
A straightforward 4 channel full range system using two channels for front, two for rear.
Connects to 4, 2, or 1 Ohm subwoofer.
Connects to 4, or 2 Ohms subwoofers.
Factors for success: design, quality, setup; weakest link; power points; headroom.
Mounting amplifiers and routing wiring away from power/speaker cables.
Using sufficient gauge cable, fuse at battery, short ground leads to chassis.
Step-by-step procedure for safely powering up the system.
Matching amplifier input sensitivity to head unit output signal level.
Explains the amplifier's diagnostic system and LED indicators.
Procedure to identify a short circuit fault in speakers or cables.
Explains shutdown due to overheating and causes.
Checks fuses, connections, and voltages at amplifier terminals.
Covers hiss and electrical interference, identifying causes and solutions.
General| Channels | 2 |
|---|---|
| THD at Rated RMS Power | <0.05% |
| Minimum Impedance Unbridged | 2 Ohms |
| Minimum Impedance Bridged | 4 Ohms |
| Bass Boost | 0 to +12dB |
| Total Harmonic Distortion | <0.05% |
| Bass Boost Frequency | 45Hz |
| Input Voltage | 200mV - 6V |
| Fuse Rating | 40A |
| Dimensions | 9.0 x 2.25 x 9.0 in (22.9 x 5.7 x 22.9 cm) |
| Input Sensitivity | 200mV - 6V |
| Crossover Type | Variable |
| Dimensions (L x W x H) | 13.0" x 9.5" x 2.2" |
To Next Page