Crux SWRTY-61N User Manual

Crux Interfacing Solutions • 21541 Nordhoff St., Unit C, Chatsworth, CA 91311
phone: (818) 609-9299 • fax: (818) 996-8188 • www.cruxinterfacing.com
rev.020320
SWRTY-61N
Radio Replacement with Steering Wheel Retention and
Rear-View Camera Retention for TOYOTA Vehicles
1 of 3
RADIO REPLACEMENT
SWC RETENTION
+
R
INTERFACING SOLUTIONS
- Retains factory features in select Toyota vehicles while funconing with an aermarket radio.
- Pre-programmed to retain factory Steering Wheel Controls.
- iPhone Voice Recognion (VR) feature from SWC on select radios.
- Retains OEM Rear View Camera.
- Retains factory USB and auxiliary audio input (aermarket radio must have these features).
- Includes factory USB retenon adapter cable.
- Supports BT-HF/A2DP/AVRCP prole on select aermarket radio models.
- Supports Pick Up/End Call, Pick up and Toggle between 1st and 2nd incoming call, AVRCP Track, Seek.
- EIA color coded wiring for easy installaon.
PRODUCT FEATURES:
PARTS INCLUDED:
INSTALLATION DIAGRAM:
SWRTY-61N MODULE SWRTY-61N HARNESS USB Retenon Cable SWC CABLE
AFTERMARKET
RADIO
SWRTY-61N
MODULE
+12V Constant Yellow
+12V ACC Red
Ground Black
Illumination Orange
Not Used
Blue/ White
Right Front (+) Gray
Right Front (-) Gray/Black
Left Front (+) White
Left Front (-) White/Black
Right Rear (+) Violet
Right Rear (-) Violet/Black
Left Rear (+) Green
Left Rear (-) Green/Black
Vehicle Speed Sense (VSS) Red/Black
Reverse Trigger Red/White
Parking Brake
(see special note below) Yellow/Black
Power Antenna Blue
Audio Input
Red/White RCA
(Retains Factory AUX Input
in Select 2007-Up Vehicles)
TO FACTORY
HARNESS
12-Pin Black
Connector
28 PIN
10 PIN
6 PIN
USB-TY01
USB Retention Adaptor
(included in kit)
Blue / Antenna Turn On
ANTENNA ADAPTOR
(Included in Kit)
Blue / Antenna Turn On
NOTE:
The BLUE Antenna Turn-On wire
should ONLY be connected to
one circuit of the aftermarket
radio. Choose the one which has
a wire populated on the factory
connector side.
24 PIN
Yellow RCA
(Retain OE Camera)
Rear View Camera Signal
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
AFTERMARKET
RADIO SELECTOR
(See Chart)
TOYOTA
SWC SETTING
(OFF ON OFF ON)
ON RADIO VEHICLE
1 2 3 4 5 6 7 8
Cap or insulate if
not being used
Kenwood/JVC (BLUE / YELLOW)
Insulate with tape
if not being used
3.5MM SWC CABLE
Plug in the 3.5MM SWC cable to the 4-pin port
on the module. See “DIP SWITCH SETTINGS” section.
To aftermarket
radio SWC port

Crux SWRTY-61N Specifications

General

Brand	Crux
Model	SWRTY-61N
Category	Automobile Accessories
Language	English

Summary

Installation Diagram and Wiring

Special Notes and DIP Switch Settings

Parking Brake Wire Special Note

Instructions for correctly inserting the parking brake wire for specific Toyota models.

Aftermarket Radio DIP Switch Settings

Configuration settings for various aftermarket radio brands to enable SWC functionality.

Toyota SWC DIP Switch Settings

Specific DIP switch settings for Toyota vehicles to retain steering wheel controls.

3.5mm SWC Cable Connection

Guidance on connecting the 3.5mm SWC cable to aftermarket radios for control.

24 to 16 Pin Adapter and Vehicle Applications

24 to 16 Pin Adapter Usage

Instructions for using an adapter to connect to vehicles with a 16-pin video input connector.

Vehicle Compatibility List

Lists compatible Scion and Toyota vehicle models for the SWRTY-61N.