Cryomagnetics Model 4G Operating Instruction Manual 40
Table 2: Computer Interface Command Summary
Select module for subsequent commands (Dual Supply only)
Query module selection (Dual Supply only)
Set error response mode for RS-232 interface
Query error response mode
Set magnet persistent current
Query power supply output current
Set low current sweep limit
Query current sweep limit
Return control to front panel (RS-232 Only)
Query selected operating mode
Control persistent switch heater
Query persistent switch heater state
Set range limit for sweep rate boundary
Query range limit for sweep rate boundary
Set sweep rate for selected sweep range
Query sweep rate for selected sweep range
Select remote operation (RS-232 Only)
Select remote operation with front panel lock (RS-232 Only)
Select shim to be queried or changed (shim option only)
Query shim selection (shim option only)
Query current limit for selected shim (shim option only)
Set current limit for selected shim (shim option only)
Start output current sweep
Set current sweep upper limit
Query current sweep upper limit
To Next Page
Loading...