User Guide
! ! !
104$Executive$$$$$$$$$ $ $ Page$2$
(4) CLI (DTMF/FSK SIGNAL) : if you have a caller ID Telephone set, you can avail this features:
Caller ID number of incoming call (Round Robin / Simultaneous).
(5) CALL PICK UP :
COMMON (INTERCOM CALL / TRUNK CALL): An extension can pick-up any ringing extension, To do so:
Dial * 4 to connect to calling extension
Hang up, when conversation is over
v Simultaneous &Auto call back Ring on an extension cannot be picked by any other extension.
v First Priority is always given to incoming call ring.
(A) SELECTIVE (INTERCOM CALL / TRUNK CALL): To do so
X = Ringing Extension number
Hang up, when conversation is over
(6) AUTOCALL BACK ON BUSY: If the dialed junction/extn. is busy, you need not try it again and again. By using this
Feature the system will automatically call you when the junction becomes free.Lift
the phone for dialing. To do so:
Dial desired junction/ Extn. Number
During Busy tone Dial “75”
(7) CALL TRANSFER: You can transfer a call either after conversation with 2
nd
extnor without consult (blind). To do so:
(A) Call Transfer (Intercom call \ Junction call):
While talking with caller
Press the Flash Key, or Flash the Hook switch
When other party answers, consult the call with him
& hang up to transfer the Call.
Hang up before other party answers. Call will
connect automatically as soon as extn answer’s.
v If by mistake you dial the wrong extension number or the dialed extn is busy / goes noreply,press the Flashkey to
Reconnect back with the external caller.
v To revert back to the call on hold after conversation with any extn.,press Flash +1.
v If the transferred call is not answered with- in 30 sec., it shall automatically disconnect.
(10) CALL TOGGLE: You can toggle between your current call (Intercom / JN) & a 2
nd
call on hold .
While talking with caller
Press the Flash Key, or Flash the Hook switch
Now Press Flash + Dial 1 for Call Toggle
Hangup when conversation is over
To Next Page
Loading...