User Guide
! ! !
104$Executive$$$$$$$$$ $ $ Page$3$
(11) HOTLINE EXTN. / JN.: This feature comes in useful when a particular extension/jn is to be used repeatedly. To do so-
Note- Refer programming manual to set delay timer for HOTLINE. Default time is 3 Sec.
(15) HOTLINE FUNCTION:
Wait for automatic dial of extn.
Start talking when set extension answers
Hang up, when conversation is over
Lift handset& Dial * 160,Get confirmation tone
(18) DYNAMICLOCK: An extension can use dynamic lock to protect misuse of outgoing trunk call’s from his extn. To do so:
To set Dynamic Lock
Dial “ *81” + self password (xxxx)
To open Dynamic Lock
Dial “ *82” + self password (xxxx)
To Change self password
XXXX = Old self password ZZZZ = New self Password
(19) CALL FORWARD: You can forward all calls to any other pre-assigned extension. This is useful when you are moving to some
Other extension and do not want your calls to remain un-attended. To do so:
X =Extn. No., where the calls are to
be forwarded
Now anyone dialing your number shall be connected to this forwarded extension.
Note: A broken dial tone is always heard on the extension with this feature enabled.
However you can make outgoing calls normally from this extn.
Cancellation of Call Forward
Lift handset& Dial * 720, get confirmation tone
To Previous Page
Loading...