3
Important to read before the first use:
This machine was tested and adjusted in the factory. Anyhow, after
transportation before and after sales, changes in temperature and humidity
and according to the conditions of bank notes to be counted a fine
adjustment is necessary before the first use. Please refer to the section
‘Setting Up’ later in this booklet. Failure to do so can result in malfunction
and damage to the machine or your bank notes. The manufacturer cannot
take any responsibility for damages of any kind caused by deviating from the
guidelines laid out in this booklet.
This booklet covers the installation, set up, maintenance and trouble shooting
for the Dolphin series Bank Note Counter. Some of the features may not be
available on your version. Please read this booklet thoroughly before operating
the Bank Note Counter.
While reading this manual please refer to the illustration at the beginning.
Caution / Installation
Select an appropriate workspace. The tabletop should be flat and level, away from
direct sunlight or close range exposure of fluorescent light. A dust- and smoke
free environment increases the life time of the machine significantly. Do not place
the machine on delicate surfaces as the rubber from the anti-slipping and anti-
vibration feet might have adverse effects.
Make sure the local voltage correspondents with the voltage as mentioned on the
rating label and preset on the voltage selector behind the back flap. This note
counter requires connection to protective earth (grounding). Please only connect
the power cord to a properly grounded socket.
Before opening the machine’s back cover or any other maintenance, switch off
the note counter and pull the plug. Before plugging in or out, make sure the power
switch on the back, located to the right side of the power cord connector, is in the
‘off’ or ‘0’ position. This machine is fused with a fuse suitable for the country of
destination. The fuse holder is incorporated with the power cord connector on the
back of the note counter. To replace the fuse, you need to unplug first. For your
convenience, there is a spare fuse in the fuse holder already. Please make sure to
replace fuses with the same type only and never repair or bridge fuses.
Dual Voltage machines have a voltage selector behind the back flap. Make sure
you do not accidentally run a machine set to 110 Volts on a network with higher
voltage.
This Bank Note Counter has an AutoStart feature that starts operation as soon as
notes are places on the hopper. Wearing loose clothes or jewellery make sure that
To Next Page
Loading...