2 • US
INTRODUCTION
The MULTI US 7002 is a primary switch mode battery charger with pulse maintenance.
The MULTI US 7002 is designed to offer maximum life for the battery. MULTI US 7002
is a member of a family of professional chargers from CTEK Power Inc. It represents the
state-of-the-art of today’s technology for battery charging. Please read these operating
instructions carefully before operating the MULTI US 7002.
IMPORTANT SAFETY INSTRUCTIONS
California Proposition 65
WARNING: This product contains chemical known to the state of California to cause
cancer or reproductive toxicity.
1.
SAVE THESE INSTRUCTIONS – This manual contains
important safety and operating instructions for battery charger models 1018.
2. When charging, batteries can emit explosive gases, therefore it is essential to pre-
vent flames and sparks. The charger is designed for charging lead-acid batteries
from 14 to 150Ah. Do not use for any other purpose. Do not expose to rain or snow.
3. Always provide good ventilation when charging.
4. Use of an attachment not recommended or sold by the battery charger manufac
-
turer may result in a risk of fire, electric shock or injury to persons.
5. To reduce risk of damage to electric plug and cord, pull by the plug rather than cord
when disconnecting charger.
6. An extension cord should not be used unless absolutely necessary. Use of im
-
proper extension cord could result in a risk of fire and electric shock. If an exten-
sion cord must be used, make sure that: a) Pins on plug of extension cord are the
same number, size and shape as those of plug on charger; b) Extension cord is
properly wired and in good electrical condition; and c) Wire size is large enough for
ac ampere rating of charger as specified in “technical data”.
7. Do not operate charger with damaged cord or plug – return the charger to the
place where purchased.
8. Never operate the charger if it has received a sharp blow, been dropped or other-
wise damaged in any way; take it to a qualified serviceman.
9. Do not disassemble charger; take it to a qualified serviceman when service or re-
pair is required. Incorrect reassembly may result in a risk of electrical shock or fire.
10. To reduce risk of electric shock, unplug charger from AC outlet before attempting
any maintenance or cleaning. Turning off controls will not reduce the risk.
To Next Page
Loading...
Need help?
General
