BASIC OPERATIONS
Turning the CTOUCH interactive display on or off
1. Plug the power cord into an AC power outlet.
2. Press Power Switch on the CTOUCH interactive display.
3. Now the CTOUCH is in standby mode. Wait a moment until the power indicator lights up, then press
button to turn on the CTOUCH interactive display.
Note: Be sure to wait for a few seconds before pressing
button. If you promptly press button then the CTOUCH interactive display may not respond or act wrongly.
4. Press
button again to turn off the CTOUCH and put the display in standby mode.
5. To cut off the power completely, press Power Switch on the back of the CTOUCH.
Note: If the VGA does not get any signal it will go into stand-by after two minutes, while others source does not get any signal it will go into stand-by mode after 10 minutes.
The rst time installation
Connect to power source and turn on the screen, the below installation menu page will display on the screen.
Select desired menu
language, then press
START and go to the
next page.
Select location and
go to the next page.
9
Select energy save
mode and go to the
next page.
To Next Page
Loading...
Need help?
General
