Cub Cadet 1535 - Page 18

Figure 20
5. PTO switch must be in the "OFF" (A) position
when shifting the tractor into reverse or the PTO
will shut off automatically. To reengage the PTO,
shift unit into neutral. Move PTO switch to "OFF"
(A) position. Then pull knob out and lift up to
"START" (B) position and release.
FRONT PTO CLUTCH BREAK-IN PROCEDURE
To break in the components and increase the life of
the clutch assembly, proceed as follows.
1. Attach mowing deck, snow thrower, etc. to the
tractor.
2. Adjust the belt tension as recommended in
attachment owner’s manual.
3. Engage and disengage the PTO ten to fifteen
times without any load (not cutting grass, not
blowing snow, etc.).
18