Cub Cadet 1782 User Manual

LUBRICATION GUIDE
Miscellaneous
Brake pedal shaft
Alignment couplings
Engine oil drain plug
and oil filter
Lubricate the brake pedal shaft and linkage with eight or ten drops of engine oil.
Use 251H EP grease or equivalent No. 2 multi-purpose lithium grease.
—After Every 200 Hours of Operation
While the engine oil is warm, remove the drain plug and oil filter (5) and drain all
of the oil from the crankcase and oil filter lines. Replace the drain plug. Refer to
"MAINTENANCE," "FILLING THE CRANKCASE" & "OIL FILTER" for proper
oil filling procedure. Refer to "LUBRICATION TABLE" for the proper quantity
and viscosity to use.
■ ^NOTE
Lubrication information for optional equipment may be found in the manual which is included with the
specific piece of optional equipment.
40

Cub Cadet 1782 Specifications

General

Horsepower	17 HP
Transmission Type	Hydrostatic
Cutting Width	50 inches
Drive	2WD
Reverse Speed	0-3.5 mph
Blades	3
Fuel Capacity	3 U.S. gallons
Cutting Height	1.0 - 4.0 inches