Cub Cadet 1806 - Tractor Operation and Pre-Checks; Before Operating Your Tractor

FUEL SHUT-OFF VALVE
The fuel shut-oft valve which is located below the
gasoline tank is used as a main fuel shut-off to the
engine. To turn the fuel on, turn the knob counter¬
clockwise to the stop. To turn the fuel off, turn the
knob clockwise until it is tight.
HOOD AND NOISE ISOLATION PANELS
The tractor hood is arranged to swing up and forward
for easy access to the engine compartment. When¬
ever engine maintenance is required, the noise isola¬
tion panels can be readily removed by removing the
two wing nuts and two washers (one on each side)
and disconnecting the panel spring. (See Figure 17.)
Figure 17
1. Noise isolation Panel (One On Each Side)
2. Panel Spring
3. Hood
OPERATION
A WARNING
RECEIVE INSTRUCTION - Read operator’s
manual. Learn to operate this machine
SAFELY. Don’t risk INJURY or DEATH.
1. Before starting engine or operation: Be
familiar with controls. Be in operator’s
position with transmission in neutral,
PTO turned off, and brake depressed.
2. Keep shields in place. Keep away from
moving parts.
3. NO RIDERS! Keep all people and pets
a safe distance away. Look before
backing up.
4. Don't point mower discharge at people.
5. Avoid slopes. Tractors can be rolled
over.
6. Before leaving operator’s position; Shut
off PTO. Place transmission In neutral.
Set parking brake. Shut off engine.
Remove ignition key. Wait for all move¬
ment to stop before servicing or clean¬
ing.
7, D o not fill gasoline tank when engine is
running or while engine is hot. Tighten
cap securely.
BEFORE OPERATING YOUR TRACTOR
1. Before you operate the tractor study this manual
carefully. It has been prepared to help you
operate and maintain your tractor with utmost
efficiency.
2. Familiarize yourself with the operation of all the
instruments and controls.
3. Fill the tank with either lead-free, low-lead or reg¬
ular gasoline. Make sure before you fill the tank
that the gasoline is clean and fresh.
4. Check the engine and transmission oil levels.
5. Clean the air cleaner element if necessary.
6. Check the tire inflation pressures.
7. Adjust the seat for operator’s maximum comfort,
visibility and complete control of the tractor.
8. Remove the noise isolation panels and clean any
accumulated grass and debris from the intake fan
on engine.
12