Cub Cadet 1882 User Manual

The filters can be obtained through your Cub Cadet
dealer under Part Number KH-52-050-02; this is the
only approved filter due to the pressure specifications
required for the 18-HP and 20-HP engines.
To change the oil filter first remove the right side
panel. Drain the oil from the engine by removing the
drain plug. Before the filter is removed, clean the out¬
side surface and mounting base of the filter. From the
operator’s position, turn the filter counterclockwise
using an automotive type filter wrench to loosen.
Before installing the new filter, apply a coating of oil on
the filter gasket. Thread the filter on by hand until tight
enough to seat the gasket. Loosen the filter.
Retighten the filter an additional one-half turn.
Replace oil drain plug and follow "FILLING THE
CRANKCASE" instructions. Check for oil leaks.
HYDROSTATIC DRIVE HYDRAULIC FLUID FILTER
NOTE
Clean the outside area before removing the
filter to keep dirt from getting into the
transmission case. If a mower is mounted
on the tractor, the mower must be lowered
to facilitate removal of the filter.
Remove the throw-away-can-type filter and replace
with a new filter after the first 10 and 50 hours of
operation, and every 100 hours of operation
thereafter. The filters can be obtained through your
Cub Cadet Dealer under part number 723-3014.
To remove the filter, turn the filter counterclockwise
using an automotive-type filter wrench.
Before installing the new filter, apply a coating of oil on
the filter gasket. Thread the new filter on by hand until
tight enough to seat the gasket. Loosen the filter.
Then turn it until the gasket contacts the base.
Tighten the filter an additional 1/2 turn. Start engine
and allow it to run for a few minutes. Shut engine off
and check for leaks; check oil level in transmission
case.
AIR CLEANER
Servicing Foam Pre-Cleaner Element
Clean and reoil foam pre-cleaner element at 1 -month
intervals or every 10 hours, whichever occurs first.
NOTE
Service more often under dusty conditions.
1. R emove wing nut and cover. (See Figure 32.)
2. R emove foam pre-cleaner element by sliding it up
off the paper cartridge.
A. Wash pre-cleaner element in liquid detergent
and water.
B. Squeeze dry in cloth.
C. Saturate in engine oil. Squeeze to distribute
oil evenly.
D. Wrap in shop towel and squeeze to remove
excess oil.
Discard used element and replace with new one at
least once a year.
Figure 32. Air Cleaner Assembly
1. Wing Nut
2. Cover
3. Rubber Tube
4. Cover Plate
5. Paper Cartridge
6. Foam Pre-Cleaner Element
7. Base Backplate
SERVICING PAPER CARTRIDGE
This engine is equipped with a dry type air cleaner
element, which should be checked every 100 oper¬
ating hours and replaced if dirty. It should be checked
and if necessary replaced more often under extremely
dirty, dusty conditions. Do not wash element in any
24

Cub Cadet 1882 Specifications

General

Brand	Cub Cadet
Model	1882
Category	Tractor
Language	English