Cub Cadet 1882 User Manual

liquid or attempt to blow dirt off with air hose as this
will puncture fitter element. Carefully handle new ele¬
ment — do not use if gasket surfaces are bent or
twisted. Check the following when installing a new
element: (See Figure 32.)
1. Backplate must be flat on gasket of carburetor
elbow. Replace backplate if bent or cracked.
2. Gasket surfaces of element must be flat against
backplate and covered to seal effectively.
3. Seal on cover must be in place to reduce noise
and vibration of the cover. Vibration can cause
stud hole in cover to enlarge, thus permitting dirt
to enter carburetor.
4. Wing nuts must be finger tight — do not over¬
tighten.
Properly cleaned and installed air cleaner elements
are the best guarantee to continued long and satisfac¬
tory engine life.
CLEANING ENGINE
This tractor has an air-cooled engine. Air must be
able to circulate freely around the engine, through the
screen, shroud and over the fins of the cylinder head
and cylinder block. Keep these areas free of accumu¬
lated dirt and trash or engine will overheat and result
in damaged moving parts. Periodically clean the
inside of the side panels and grille insert for adequate
cooling.
Hl^ NOTE
This machine is designed to cool properly
with the engine side panels in place. Oper¬
ating the machine without panels in place
may result in inadequate cooling.
SPARK PLUGS
A WARNING
To avoid possible injury, be sure engine is
off and cool before making any adjustment
or repairs.
■ ^NOTE
Remove all dirt from around the spark plugs
before removing.
To remove spark plugs, always use a spark plug
wrench. Check gap after every 100 hours of opera¬
tion.
Replace a defective plug with a new plug. Set gap at
.025 inch. (See Figure 33.) Tighten plug to 10-15 ft-
Ibs. See your authorized dealer for the correct
replacement plug.
Figure 33
1. SparkPlug
CLEANING OF CYLINDER HEADS
Cleaning of the cylinder heads should only be done by
your authorized Cub Cadet Dealer. This process is to
be done to keep your engine properly cooled and at its
peak efficiency. The frequency of cleaning is depen¬
dent upon the type of fuel used. When leaded fuel is
used the cleaning interval is 250 hours, and with
unleaded fuel the cleaning interval is 500 hours.
FUEL FILTER
^^ WARNING
Do not replace fuel filter when engine is hot.
The engine is equipped with an inline fuel filter. Visu¬
ally inspect the filter periodically. Replace dirty filter.
LIGHTS
Refer to "SPECIFICATIONS" when replacement of
head lamp bulb or taillight bulb is necessary.
^^ WARNING
Do not change head lamp bulbs when hot or
when engine is hot.
A CAUTION
Do not touch glass portion of head lamp
bulb. Touching glass portion will reduce life
of head lamp bulb.
25

Cub Cadet 1882 Specifications

General

Brand	Cub Cadet
Model	1882
Category	Tractor
Language	English