EasyManuals Logo

Cub Cadet Big Country 431D User Manual

Cub Cadet Big Country 431D
24 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #10 background imageLoading...
Page #10 background image
10
WARNING: Make sure seat is in locked
position prior to operation and do not try to
adjust the seat position while operating the
vehicle.
Figure 10
Cargo Box
The cargo box is raised by a gas spring. Manually
remove the contents of the cargo box before lifting the
cargo box. Release the latch and lift up the cargo box.
Once the cargo box is in the raised position, access to
the engine is possible. If equipped with a electrical lift,
the cargo box can be raised to dump cargo. See Figure
11.
WARNING: Do not exceed the vehicle’s
Total Load Capacity of 1,200 lb., which
includes driver, passenger, accessories, and
cargo. Do not exceed 800 lb. in the cargo box
Figure 11
Tailgate
The tailgate can be hinged at the top or the bottom
depending on how you release the holding pins. If you
pull out on the two top pins, the tailgate will swing down.
If you pull out the two bottom pins, you can pivot the
tailgate upwards.
SECTION 3: OPERATING YOUR UTILITY VEHICLE
WARNING: This is an off-road utility vehicle
and it should not be operated on public
highways. Know and comply with all laws and
regulations governing the use of off-highway
vehicles in your area.
IMPORTANT:
Before starting the engine read this
manual and the Kohler Engine manual thoroughly to
understand all instructions.
WARNING: Do not run an engine in an
enclosed area. Move the vehicle to an
outside area before running the engine.
IMPORTANT:
Tires are shipped over-inflated. Reduce
inflation pressure in all tires to approximately 5 -6 psi.
Check Neutral Safety Switch
Sit in the operator’s seat and place key switch in
STOP position.
Engage the parking brake, raise and secure cargo
box, and move lever to the forward position. See
Figure 12.
Sit back down in operator’s seat and move key
switch to START position. The engine should NOT
crank.
Turn key switch to STOP and move lever to the
reverse position.
Figure 12
Sit back down in operator’s seat and move key
switch to START position. The engine should NOT
crank.
Turn key switch to STOP.
Lower and relatch the cargo box.
Keep engine compartment clean and be sure fan or
flywheel screens remains installed and clean.
Seat Lever
Cargo Box
Lever

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet Big Country 431D and is the answer not in the manual?

Cub Cadet Big Country 431D Specifications

General IconGeneral
BrandCub Cadet
ModelBig Country 431D
CategoryUtility Vehicle
LanguageEnglish

Related product manuals