-
9-
STARTING
WARNING
Before starting the engine, keep the cutting
attachment clear of everything around it.
WARNING
Exhaust gases contain carbon monoxide, and
colorless, odorless,poisonous gas. Do not
operate the engine in enclosed areas. Provide
adequate ventilation at all time.
1. Use the mixing tank to mix the fuel and oil.
Fill fuel tank with the mixture. See “Fuel and Oil
Instructions”.
2. Push the ignition switch to the “Run” positon.
3. Make sure throttle lockout and throttle trigger
at the released position.
Run
Ignition Switch
Throttle Lockout
Throttle Trigger
Stop
4. Fully press and release the primmer bulb for 10
times. Some amount of fuel should be visible
in the primer bulb and fuel lines.
5. Move choke lever to the position.
6. When the engine is already warm or on hot
days, set the choke lever to the position.
Close
Fully Open
Choke Lever
7. put the machine on at ground,make sure the
cutting attachment is clear ot everything
around it.Hold the unit with your left hand and
press it against the ground.While holding the
starter handle in right hand. Gently pull the
starter rope out until you feel that the pawls
hook onto the ywheel, and then pull the
starter quickly.
8. Repeat several times until the engine starts.
9. After starting the engine, run the engine at
the idling speed for a 2-3 minutes to warm up
according to the dierent temperature.
WARNING
Releasing the starting rope suddenly may allow
the rope to whip around and cause injury and/
or damage the recoil starting mechanism. When
starting engine,rmly grasp the recoil starter
grip; do not grasp the starter rope itself. Always
control the rope as it rewinds into the housing.
1.If the engine fails to start, do not try to
pull the recoil starter too many times with
the choke lever to the position. Just move
choke lever to the position. Repeat to
pull the recoil starter grip until the engine
starts.
OPERATING INSTRUCTIONS
To Next Page
Loading...
Need help?
General
