Electrical
6‐7
Checking the Fuses
Note:
Always turn the main switch off when
checking or replacing a fuse.
Set tester to Ohms X 1 position.
If the tester indicates ∞ or OL replace the
fuse.
Fuses will be found in 2 places on the
UV.
Inside the battery box
Inside the centralized relay box on
the fire wall.
After testing and replacement of the fuse,
turn on the main switch to energize and
check the circuit that was affected.
If the fuse blows immediately check the
rest of the circuit for a short.
WARNING:
Never use a fuse with a rating other
than that specified. Never use materials
in place of a fuse. An improper fuse can
cause extensive damage to the
electrical system up to and including a
fire.
To Next Page
Loading...
