4-6 Control Functions
Speedometer unit functions:
a speedometer (which shows the speed)
an odometer (which shows the total
distance covered)
a trip-meter (which can be cleared and
then show any new distances traveled)
an RPM indicator (which shows the
revolutions per minute of the engine)
a clock
an Electronic Fuel Injection (EFI) fault
code indicator (which shows the fault
code for problems with the EFI )
Odometer and trip meter modes
On the display panel there are two large
buttons, one located on the left side and one
on the right side. Quickly pressing the
button on the left side toggles the display
from the odometer, to the trip-meter, and
then to the hours meter; then it starts the
cycle over.
The odometer displays the total distance
traveled by the UTV. The trip-meter records
distances for a specific trip and can record
distances from 0 through 999.9 miles.
To reset a trip meter, select it by pressing the
left button, Press left button to switch to
small mileage (Trip), press and hold the
right button to reset. The trip-meter can
be used to estimate the distance that can
be traveled with a full tank of fuel.
This information will enable you to judge
the fuel consumption.
To change the display from miles per hour to
To Next Page
Loading...
Need help?
General