8
ASSEMBLY AND OPERATING
CHARGING THE POWER CELL
WARNING: Use only the
CRC8000 rapid charger to charge the
CFC6500, 20V Li-Ion Power Cell.
Charging any other Power Cells or
batteries with this charger may
damage the Power Cells, batteries, or
charger, and possibly cause serious
injury or property damage from fire,
explosion or hazardous fumes.
1. To charge the Power Cell, place
the charger (1) in a dry location
near a 120 V AC, 60 Hz electrical
outlet and plug it into the outlet
(Fig. 1).
NOTE:
Both the red and green LEDs will turn
ON, indicating that power is actively
being supplied to the charger and
that the charger is ready to charge a
Power Cell. If the LEDs do NOT turn
ON, the charger is not receiving
power from the electrical outlet or the
charger is not functioning properly.
2. Insert the Power Cell (2) into the
matching cavity (3) in the top of
the charger.
NOTES:
a) Make sure the "TOP" marking (4)
on top of the Power Cell is facing
toward the LED lights (5 & 6) on
the charger.
b) Make sure the Power Cell is
pressed fully into the charger cavity.
1
5
6
3
4
2
To Next Page
Loading...
Need help?
General