Problem Cause Remedy
Engine fails to start îąîľî°îîŁîîî
îîîŚîîîîîîîîîîîîîîîîîî
îîîî
Parking brake not engaged. 2.
Spark plug wire(s) disconnected. îîî
Throttle/choke control lever not in correct 4.
starting position.
Fuel tank empty, or stale fuel. 5.
Blocked fuel line. 6.
Faulty spark plug(s). 7.
Engine flooded. 8.
îąîîîîîîîîîîîîîî
îîîîîîîîî
îîî°î§î§îîîîîîîîîîîîîîî
Engage parking brake. 2.
Connect wire(s) to spark plug(s). îîî
îąîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîî¤îŠî°îŹîŚî4.
position.
î§îîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîîî
îîîî5.
old) gas.
Clean fuel line and replace fuel filter. 6.
Clean, adjust gap or replace plug(s). 7.
Crank engine with throttle in FAST position. 8.
Engine runs erratic îľîîîîîîîîîîîîîîîîîîîîî¤îŠî°îŹîŚîîîîîîîîîî
îî îîî
Spark plug wire(s) loose. 2.
Blocked fuel line or stale fuel. îîî
Vent in gas cap plugged. 4.
Water or dirt in fuel system. 5.
Dirty air cleaner. 6.
îŽîîîîîľîîîîîîîîî¤îîîîîîîîîîîîîîîîîîîîî¤îŠî°îŹîŚîîîî
position.
Connect spark plug wire(s). 2.
Clean fuel line; fill tank with clean, fresh îîî
gasoline and replace fuel filter.
Clear vent or replace cap if damaged. 4.
Drain fuel tank. Refill with clean, fresh 5.
gasoline.
Replace air cleaner paper element or clean 6.
foam pre-cleaner.
Engine overheats Engine oil level low. îîî
Air flow restricted. 2.
Fill crankcase with proper amount and îîî
weight of oil.
Clean grass clippings and debris from around 2.
îîîîîîîîîîîîîîîîîîîîîîîîîîîîî
îîîîîîîîîîîîîîîîî
Engine hesitates at high
RPM
Spark plug(s) gap too close. îîî Remove spark plug(s) and reset the gap. îîî
Engine Idles rough Spark plug(s) fouled, faulty or gap too wide. îîî
Dirty air cleaner. 2.
Replace spark plug(s). Set plug gap. îîî
Replace air cleaner element and/or clean 2.
pre-cleaner.
Excessive vibration Cutting blade loose or unbalanced. îîî
Damaged or bent cutting blade. 2.
Tighten blade and spindle. îîî
Replace blade. 2.
Mower will not mulch grass Engine speed too low. îîî
Wet grass. 2.
Excessively high grass. îîî
Dull blade. 4.
Place throttle in FAST (rabbit) position.îîî
Do not mulch when grass is wet. 2.
Mow once at a high cutting height, then îîî
mow again at desired height or make a
narrower cutting swath.
Sharpen or replace blade. 4.
Uneven cut Deck not leveled properly. îîî
Dull blade. 2.
Uneven tire pressure. îîî
Perform side-to-side deck adjustment. îîî
Sharpen or replace blade. 2.
Check tire pressure in all four tires. îîî
Troubleshooting
8
30