Cub Cadet LTX1046 User Manual

6.

7.
Move the deck lift lever into the top notch to raise the deck 8.
lift arms up and out of the way.
Remove the cotter pin from the end of the stabilizer rod 
and slide the stabilizer out of the hanger bracket on the

Gently slide the cutting deck (from the right side) out from 
underneath the tractor.
Deck Lift
Arm
Deck Support
Pin
Cutting Blades
WARNING! 
ignition key before removing the cutting blade(s) for

using heavy gloves when grasping the blade.
WARNING! 

struck a foreign object. Do not operate the machine
until damaged components are replaced.
To remove the blades, proceed as follows.
Remove the deck from beneath the tractor, (refer to 
Cutting Deck Removal earlier in this section) then gently
flip the deck over to expose its underside.
2.
baffle and the cutting blade to act as a stabilizer.

Remove the flange lock nut that secures the blade to the 

Figure 7-4
Figure 7-3
Figure 7-5
25se c t i O n 7 — se r v i c e

Cub Cadet LTX1046 Specifications

General

Engine Brand	Kohler
Engine Model	Courage
Engine Displacement	725cc
Horsepower	22 HP
Cutting Width	46 inches
Transmission Type	Hydrostatic
Deck Material	Steel
Deck Positions	12
Cutting Height	1.5 - 4 inches
Number of Blades	2
Turning Radius	12 inches
Front Tire Size	15 x 6 in
Rear Tire Size	20 x 8 in
Warranty	3-year limited