Assembly & Set-Up
3
9
Contents of Carton
• One Pressure Washer • One Handle • One Spray Gun
• One Pressure Washer Operator’s Manual • One High Pressure Hose • Four Quick-Connect Nozzles
• One Engine Operator’s Manual • One Quick-Connect Spray Wand • One Bottle of Oil
Nozzles
1. Remove the colored quick-connect nozzles from the plastic
bag and insert them into correct grommet on the nozzle
holder. Nozzles are color coded to match colored nozzles
on label. See Figure 3-2.
Figure 3-2
Wand to Gun
1. Connect wand to gun. Tighten securely. See Figure 3-3.
Figure 3-3
Assembly
NOTICE: This unit is shipped without gasoline or oil in
the engine. Fill up with gasoline and oil as instructed in the
accompanying engine manual BEFORE operating your pressure
washer.
NOTE: The pump on this unit is maintenance free and requires
no oil. If there is a problem with the pump, a Customer Support
Representative at (800) 965-4CUB as soon as possible.
Handle
1. Place handle onto frame , depress the snap buttons,
and slide the handle assembly onto the frame until snap
buttons snap into place. See Figure 3-1.
NOTICE: Risk of personal injury. Avoid placing hands between
handle and frame when assembling to prevent pinching.
Figure 3-1
To Next Page
Loading...
