EasyManuals Logo

Cub Cadet RZT42 User Manual

Cub Cadet RZT42
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
Push the oil drain hose (packed with this manual) onto the oil 4.
drain port. Route the opposite end of the hose into an
appropriate oil collection container with at least a 2.5 quart
capacity, to collect the used oil.
The engine is equipped with either a twist-and-pull drain 5.
port or a tabbed drain port. If your engine has the twist-
and-pull drain go to step a. If your engine is equipped with
the tabbed drain go to step b.
Turn the oil drain valve a. ⁄-turn, then pull outward to
begin draining oil. After the oil has finished draining,
push the end of the oil drain valve back in and turn
⁄turn to secure it back in place Re-cap the end of
the oil drain valve to keep debris from entering the
drain port.
Pinch the tabs on the oil drain valve, then pull b.
outward to begin draining oil. After the oil has
finished draining, push the end of the oil drain valve
back in, until the tabs click into place. Re-cap the end
of the oil drain valve to keep debris from entering
the drain port.
After the oil has finished draining, push the end of the oil 6.
drain valve back in, until the tabs click into place. Re-cap
the end of the oil drain valve to keep debris from entering
the drain port.
Replace the oil filter, and refill the engine with new oil as 7.
instructed in the Kohler Owner’s Manual.
Air Cleaner
Service the pre-cleaner and cartridge/air cleaner element as
instructed in the Owners Manual.
Spark Plug
The spark plugs should be cleaned and the gap reset once a
season. Refer to the Owners Manual for correct plug type and
gap specifications.
Hydrostatic Transmission
The zero turn tractor is equipped with dual integrated
hydrostatic pumps/transaxles that are sealed and are
maintenance-free. Fluid levels cannot be checked and fluid
cannot be added or changed.
General Battery Information
WARNING!
Should battery acid accidentally splatter into •
the eyes or onto the skin, rinse the affected area
immediately with clean cold water. If there is any
further discomfort, seek prompt medical attention.
If acid spills on clothing, first dilute it with •
clean water, then neutralize with a solution of
ammonia/water or baking soda/water.
NEVER connect (or disconnect) battery •
charger clips to the battery while the charger is
turned on, as it can cause sparks.
Keep all sources of ignition (cigarettes, •
matches, lighters) away from the battery. The gas
generated during charging can be combustible.
As a further precaution, only charge the •
battery in a well ventilated area.
Always shield eyes and protect skin and •
clothing when working near batteries.
Batteries contain sulfuric acid and may •
emit explosive gases. Use extreme caution when
handling batteries. Keep batteries out of the reach
of children.
Battery Maintenance
The battery is filled with battery acid and then sealed at •
the factory. However, even a “maintenance free” battery
requires some maintenance to ensure its proper life cycle.
Spray the terminals and exposed wire with a battery •
terminal sealer, or coat the terminals with a thin coat of
grease or petroleum jelly, to protect against corrosion.
Always keep the battery cables and terminals clean and •
free of corrosion.
Avoid tipping. Even a sealed battery will leak electrolyte •
when tipped.
WARNING! Batteries contain sulfuric acid and may
emit explosive gases. Use extreme caution when
handling batteries. Keep batteries out of the reach
of children.
Tire Maintenance
Check the tire air pressure after every 50 hours of operation or
weekly. Keep the tires inflated to the recommended pressures.
Improper inflation will shorten the tire service life. See the tire
side wall for proper inflation pressures. Observe the following
guidelines:
Figure 6-1
Oil Filler
Oil Fill Cap/Dipstick
Oil Drain Valve
Oil Fill Tube
23se c t i O n 6 — Ma i n t e n a n c e & ad j u s t M e n t s

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet RZT42 and is the answer not in the manual?

Cub Cadet RZT42 Specifications

General IconGeneral
Cutting Width42 inches
Fuel Capacity3 gallons
Deck ConstructionStamped
Transmission TypeHydrostatic
Deck MaterialSteel
Engine TypeOHV
TransmissionHydrostatic
Turning RadiusZero-turn
Cutting Height Range1.5 - 4 inches
TypeZero-Turn
Speed7 mph forward / 3 mph reverse
Warranty3-year limited
EngineKohler 6000 Series

Related product manuals