EasyManuals Logo

Cub Cadet RZT42 User Manual

Cub Cadet RZT42
84 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #36 background imageLoading...
Page #36 background image
Problem Cause Remedy
Engine fails to start PTO/Blade Engage knob engaged.1.
Parking brake not engaged. 2.
Drive control levers not fully outward in 3.
neutral position.
Spark plug wire(s) disconnected. 4.
Throttle/choke control lever not in correct 5.
starting position.
Choke not activated. 6.
Fuel tank empty, or stale fuel. 7.
Blocked fuel line. 8.
Faulty spark plug(s). 9.
Engine flooded. 10.
Place knob in disengaged (OFF) position. 1.
Engage parking brake. 2.
Move drive control levers fully outward in 3.
neutral position.
Connect wire(s) to spark plug(s). 4.
Place throttle/choke lever to choke position. 5.
Push throttle/choke control lever to choke 6.
position.
Fill tank with clean, fresh (less than 30 days 7.
old) gas.
Clean fuel line and replace fuel filter. 8.
Clean, adjust gap or replace plug(s). 9.
Crank engine with throttle in FAST position. 10.
Engine runs erratic Tractor running with CHOKE activated. 1.
Spark plug wire(s) loose. 2.
Blocked fuel line or stale fuel. 3.
Vent in gas cap plugged. 4.
Water or dirt in fuel system. 5.
Dirty air cleaner. 6.
Pull the throttle/choke control lever rearward 1.
from the choke position
Connect spark plug wire(s). 2.
Clean fuel line; fill tank with clean, fresh 3.
gasoline and replace fuel filter.
Clear vent or replace cap if damaged. 4.
Drain fuel tank. Refill with clean, fresh 5.
gasoline.
Replace air cleaner paper element or clean 6.
foam pre-cleaner.
Troubleshooting
9
36

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet RZT42 and is the answer not in the manual?

Cub Cadet RZT42 Specifications

General IconGeneral
Cutting Width42 inches
Fuel Capacity3 gallons
Deck ConstructionStamped
Transmission TypeHydrostatic
Deck MaterialSteel
Engine TypeOHV
TransmissionHydrostatic
Turning RadiusZero-turn
Cutting Height Range1.5 - 4 inches
TypeZero-Turn
Speed7 mph forward / 3 mph reverse
Warranty3-year limited
EngineKohler 6000 Series

Related product manuals