LUBRICATION TABLE
Check
at
Hours
Anticipated Air Temperature
0° to 40°F -20°F tO 100°+
Change
Point of at Capacity
Lubrication Hours Above +40°F
Engine crankcase Check 50 Approx, Cub Cadet Cub Cadet Synthetic
before 3 pints Engine Oil Engine Oil Engine Oil SAE
each SAE 30 SAE5W30 5W30 or 10W30
use or 10W30
Hydro drive unit and Check Add as Approx. Cub Cadet Drive System Fluid Plus
transmission case before needed 6 qts NOTE: Cub Cadet Drive System Fluid Plus is specially
with filter each formulated for this application, If any other oil is used
use Cub Cadet will not be responsible for substandard
performance, Failures due to use of improper fluid
are not covered by warranty, For maximum protec-
tion, use Cub Cadet Drive System Fluid.Plus
Steering knuckles 10 Use 251H EP grease or equivalent No, 2 multi-
and front axle purpose lithium grease and apply two strokes
pivot bolt (minimum) or sufficient grease to flush out old
grease and dirt.
Front wheel 30 Two strokes (minimum) of the lubricator using 251H
bearings EP grease or equivalent No. 2 multi-purpose lithium
grease.
Steering arm 30 Two strokes (minimum) of the lubricator using 251H
housing EP grease or equivalent No. 2 multi-purpose lithium
grease.
Deck spindles 10 Two strokes (minimum) of the lubricator using 251H
EP grease or equivalent No. 2 multi-purpose lithium
grease.
Spindle belt 10 Two strokes (minimum) of the lubricator using 251H
idler arm EP grease or equivalent No. 2 multi-purpose lithium
grease.
Deck front gauge 50 Use 251H EP grease or equivalent No. 2 multi-purpose
wheels lithum grease.
Foot and lift con- 10 Use a liberal amount of high grade lubricating oil.
trol pivot points
51
To Next Page
Loading...
Need help?
General
