Section 5— operation22
6.  Move the throttle control lever forward to the full throttle 
(FAST)   position. 
NOTE: Although the tractor’s engine is designed to run at 
full throttle, when performing a practice session the tractor 
must be operated at less than full throttle. This only applies 
to practice.
WARNING! Always maintain a firm grip on the 
control levers. DO NOT release the control levers to 
slow or stop the tractor; move levers to neutral 
position using your hands.
7.  To drive the tractor, firmly grasp the respective drive 
control levers with your right and left hands and continue 
with Driving the Tractor Forward below.
Driving the Tractor Forward 
WARNING! Keep all movement of the drive control 
levers slow and smooth. Abrupt movement of the 
control levers can affect the stability of the tractor 
and could cause the tractor to flip over, which may 
result in serious injury or death to the operator.
1.  Slowly and evenly move both drive control levers forward. 
The tractor will start to move forward. See Figure 5-2.
Driving Forward
Faster
Slower
Neutral
Position
Figure 5-2
2.  As the control levers are pushed farther forward the speed 
of the tractor will increase.
3.  To slow the tractor move the controls lever rearward to 
attain the desired speed, or move the levers to the neutral 
position to stop the tractor.
WARNING! Always maintain your grasp on the 
drive control levers. Do not release the levers to slow 
the tractor or to return to neutral.
Turning the Tractor While Driving Forward
WARNING! When reversing the direction of travel, 
we recommend performing gradual ‘U’ turns where 
possible. Sharper turns increase the possibility of turf 
defacement, and could affect control of the tractor. 
ALWAYS slow the tractor before making sharp turns.
To turn the tractor while driving forward, move the control 
levers as necessary so that one lever is rearward of the other. The 
tractor will turn in the direction of the rearward control lever. 
1.  To turn to the left, move the left drive control lever 
rearward of the right lever. See Figure 5-3.
Figure 5-3
2.  To turn to the right, move the right drive control lever 
rearward of the left lever. See Figure 5-4.
Figure 5-4