Cub Cadet Tank M54-KH - Position Drive Control levers

11se c t i O n 2 — as s e M b l y & se t -up
4.
Install the (⁄

5.
hardware is installed.
6.

NOTE: Make sure tubular upright posts are absolutely tight
within welded bracket.
7.

8.


Position Drive Control levers
The drive control levers of the tractor are lowered for shipping
purposes. Using the hardware found in the manual bag, the
control levers must be repositioned to operate the tractor. To
reposition the control levers for operation, proceed as follows:
Lift and swing the control levers up into the operating 
position.
From the outside, insert the bolts through the hourglass 2.


Refer to “Adjusting Drive Control Levers” section for 
instructions on the final adjustment of the levers.
Hex Bolts
Washers
Nuts
Lower ROPS Posts
Figure 3-3
Rubber Plug
Figure 3-4
Locking Pin
Hairpin
Clips
Figure 3-5
Hourglass
Spacer
Nut
Bolt
Figure 3-6