EasyManuals Logo

Cub Cadet Volunteer 4x4 EFI User Manual

Cub Cadet Volunteer 4x4 EFI
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #23 background imageLoading...
Page #23 background image
Tro ubleshooting
10
23
Problem Cause(s)
Engine will not start 1. Battery has low voltage.
2. Loose or corroded battery connections.
3. Fuse is blown.
4. Spark plug wire is loose or disconnected.
5. Faulty spark plug or coil.
6. No Fuel or improper fuel.
7. Plugged fuel filter.
8. Defective starter solenoid.
9. Open-circuit in wiring.
Engine is difficult to start 1. Engine is cold.
2. Plugged fuel filter.
3. Engine oil viscosity too heavy.
4. Spark plug is fouled.
5. Faulty spark plug or wire.
6. Loose or corroded electrical connections.
7. Stale or improper fuel.
8. Choke (if equipped) not being used or adjusted properly.
Engine misses under load 1. Faulty spark plug.
2. Stale or dirty fuel.
3. Plugged fuel filter.
4. Faulty coil or wire.
Engine vapor locks 1. Poor quality fuel.
2. Very hot weather conditions.
3. Fuel tank vent plugged.
4. Dirt in fuel filter.
Engine runs unevenly 1. Loose electrical connections.
2. Choke (if equipped) or throttle cable sticking.
3. Fuel line or fuel filter plugged.
4. Stale or dirty fuel.
5. Improper fuel.
6. Air cleaner element plugged.
7. Spark plug is fouled.
Continued on next page

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Cub Cadet Volunteer 4x4 EFI and is the answer not in the manual?

Cub Cadet Volunteer 4x4 EFI Specifications

General IconGeneral
BrandCub Cadet
ModelVolunteer 4x4 EFI
CategoryUtility Vehicle
LanguageEnglish

Related product manuals