18
SERVICE AND MAINTENANCE
General LCD Screen Messages
Message Description
Battery Temperature Low:
Move the tractor to a warm
location and allow the battery to
warm. If problem persists contact
qualified service personnel.
High Deck/Drive Motor Temp
High Battery Temp
High Temperature: Power off,
let the tractor cool and restart
tractor. If problem persists contact
qualified service personnel.
Unplug Cord/ Close Charge
Port Door: Prior to powering on
and operating the tractor, cord
must be unplugged and charge
port door closed securely.
Cruise Control ON: Cruise control
is set when icon is displayed.
Cut Deck Overload: The deck and
drive shut off. Power off the tractor,
clean under the deck as instructed
in the Post-Operation Tractor Care
section and restart the tractor. Raise
the deck and/or cut at a slower pace.
If problem persists contact qualified
service personnel.
Faults
Faults are displayed as four digit codes with the first number (after “E”) relating to
the affected subsystem. These faults may shut off the deck and drive or the entire
tractor. If these occur, power off the tractor and allow it to cool, then restart the
tractor. If these faults persist, contact qualified service personnel.
Code Description
All VCM Related Faults
Left Deck Motor Faults/Single
Deck Motor Faults
Right Deck Motor Faults
(If equipped)
Center Deck Motor Faults
(If equipped)
Left Drive Motor Faults/Single
Drive Motor Faults
Right Drive Motor Faults
(If equipped)
Battery Faults
Battery Faults
Battery Faults
To Next Page
Loading...
