Cub Cadet Z-Force S 60

28 se c t i O n 7— se r v i c e
After all four cotter pins are secure, slide the deck forward 5.
and hook the deck to the U-rod.
Route the belt as shown in Fig. 7-8. After routing the belt 6.
⁄
bracket and turn towards the back of the tractor to finish
routing the belt around the idler pulley.
7.
the click pin and push the pedal forward and rock back to
lock into the transport position, locking behind the notch
on the front of the index plate.
8.
the deck if required.
Make sure the proper tension is on the belt. To adjust the 

NOTE: 
routing to make sure that the belt has been routed
properly.
Deck Installation
Install the deck on the tractor as follows:

and secure it by placing the click pin behind the pedal.

2.
tractor lining up the deck lift adjustment brackets and the


to the lowest mowing position.
NOTE: To make the brackets line up properly it may be
necessary to place a small block of wood under each side
of the deck.
4.
deck lift adjustment bracket into the lift bracket and secure

Deck Lift Adjustment Brackets
Deck Lift Brackets
Figure 7-6
PTO Pulley
PTO Belt
Deck Belt
Figure 7-7
Cotter
Pin
Bracket Pin
Figure 7-8