© CUB CAMPERS • 2.2 OWNER’S MANUAL V2 • 20/12/2022 PAGE 10 of 32
7. Step out of the camper (lifting slide
bracket and retightening if preferred to
allow easy exit from camper). Close the
front zip, leaving about 25cm open to
allow air to escape.
8. Walk around the camper and unclip all
press studs/shock cords from the trailer
body and tent lifting the canvas back into
the trailer body on both sides where the
trailer body angles downwards at
approximately 45 degrees. Ensure care is
taken to raise the canvas above and over
the weather seal to avoid any
unnecessary damage to the weather sealing
of the trailer.
9. IT IS IMPORTANT that the canvas tent is pulled out and away from
the tent bow junction point before you start closing the camper.
This will avoid any possibility of the canvas being caught or catching
on the tent bow junction point.
FAILURE TO TAKE CARE WITH HOW THE CANVAS IS FOLDED INTO THE TRAILER
AT THIS POINT MAY RESULT IN DAMAGE TO THE CANVAS.
10. Commence winding the winch.
11. When the camper trailer roof/floor is “about” two thirds closed, walk
around the camper, and ensure that all the canvas is pushed inside
the body of the camper. It is safe to do this when the last tent bow
is flat on the camper.
Lift canvas back into body
To Next Page