© CUB CAMPERS • 2.2 OWNER’S MANUAL V2 • 20/12/2022 PAGE 11 of 32
12. Position the winch strap behind the roller, this changes the
direction of the pull of the winch strap on the hard floor/roof and
allows for greater ease in closing the roof/floor onto the trailer
body.
13. Continue winding, but do not fully close with the
winch. Stop winding when there is a gap of
approximately 25mm to 50mm, then engage the
two-rear lock down latches. This will preserve the
weather seal of the camper.
14. Commencing from the rear of the trailer, close the latches finishing
with the front latches, ensuring that no canvas is protruding over
the seal.
15. Wind the 2 stabiliser legs back up, release the red locking handle,
and swing up underneath the body and release the red handle to
lock into place.
16. If the camper has a rear utility swing arm, close and latch it securely.
17. As the
Cub
is fitted with a self-braking winch, the winch strap should
be reasonably “tight” so that the winch handle is not left to swing
freely in transit.
18. The
Cub
is now ready to be attached to the towing vehicle.
To Next Page