© CUB CAMPERS • 2.2 OWNER’S MANUAL V2 • 20/12/2022 PAGE 7 of 32
12. Release the locking screw on the slide bracket
just inside the zip door (this is the fitting that
secures the rear diagonal bar to the centre
upright bar). Release the adjusting screw on
the doorway side of the rear tent bow to
temporarily take the tension off, then raise
the diagonal bar upwards until it reaches a
horizontal position above the doorway
13. Tighten the locking screw on the slide bracket to lock this bar in a
horizontal position above the doorway, and gently push the rear
bow outwards (if it has slackened off), then retighten the tent bow
adjusting screw.
Refer to separate instructions for awning/annexe set-up.
Connection to 240-volt electricity
A 15-amp extension cord is required if connecting to a 240 volt supply
(e.g. at a Caravan Park). This is connected to the inlet on the driver’s
side of the camper.
Connecting gas & water
Connect the gas and water from the access point on the rear of the
kitchen. Open gas and water valves.
Release locking screw on slide bracket
To Next Page
Loading...